The 3 connectors are NO (normally open) NC (normally closed) and the Ground (more)...

[ Follow Ups ] [ Post Followup ] [ Build Your Own Arcade Controls message board ] [ FAQ ]

Posted by JLR2000 on 12, 2001 at 5:50 PM:

In Reply to: Still stuck on this control panel wiring posted by Jason on 12, 2001 at 5:37 PM:

: Hey guys,

: I'm still kind of stumped on wiring up my control panel to the encoder (hagstrom ke72)...

: There are 3 connectors that come off of each microswitch... which ones do I wire up? Where do I wire them up to? What about the grounds?

: I'm looking to wire them up with ide ribbon and 25pin cable (so i can unhook a control panel easily and swap it w/ a different one) sort of like MrSalty's (link at bottom) setup.

: Would someonoe here help me out?
: dunno how to properly wire up the buttons and joystick to the encoder.. there are 3 connectors from the switch and i'm stumped :/

Follow Ups:

Re: The 3 connectors are NO (normally open) NC (normally closed) and the Ground (more)... ArcadEd 4/13/2001 (1)
- Guess Not ArcadEd 4/13/2001 (0)
Sorry, here's the (more)... JLR2000 4/12/2001 (0)

Post a Followup

Name:
E-Mail:

Subject:

Comments:
: : Hey guys, : : I'm still kind of stumped on wiring up my control panel to the encoder (hagstrom ke72)... : : There are 3 connectors that come off of each microswitch... which ones do I wire up? Where do I wire them up to? What about the grounds? : : I'm looking to wire them up with ide ribbon and 25pin cable (so i can unhook a control panel easily and swap it w/ a different one) sort of like MrSalty's (link at bottom) setup. : : Would someonoe here help me out? : : dunno how to properly wire up the buttons and joystick to the encoder.. there are 3 connectors from the switch and i'm stumped :/

Optional Link URL:
Link Title:
Optional Image URL:

[ Follow Ups ] [ Post Followup ] [ Build Your Own Arcade Controls message board ] [ FAQ ]