Guess Not


[ Follow Ups ] [ Post Followup ] [ Build Your Own Arcade Controls message board ] [ FAQ ]

Posted by ArcadEd on 13, 2001 at 4:11 PM:

In Reply to: Re: The 3 connectors are NO (normally open) NC (normally closed) and the Ground (more)... posted by ArcadEd on 13, 2001 at 4:10 PM:

Well it looks good when hit post follow up and look at in the text box. Anyway, the one connector out the side, and the one closes to it coming out the bottom are the two.

: Just to add to waht JLR2000 Stated, I thought I would test my ascii Skills, here is the two you need to connect. So According to the great pick, the left two are the ones you use. Geez, I hope this makes sense when I hit POST.
: ______
: | |
: _| |
: | | |
: | | |
: |______|
: |
: |
:


:
: : : Hey guys,

: : : I'm still kind of stumped on wiring up my control panel to the encoder (hagstrom ke72)...

: : : There are 3 connectors that come off of each microswitch... which ones do I wire up? Where do I wire them up to? What about the grounds?

: : : I'm looking to wire them up with ide ribbon and 25pin cable (so i can unhook a control panel easily and swap it w/ a different one) sort of like MrSalty's (link at bottom) setup.

: : : Would someonoe here help me out?
: : : dunno how to properly wire up the buttons and joystick to the encoder.. there are 3 connectors from the switch and i'm stumped :/




Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Optional Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Build Your Own Arcade Controls message board ] [ FAQ ]