Posted by ArcadEd on 13, 2001 at 4:10 PM:
In Reply to: The 3 connectors are NO (normally open) NC (normally closed) and the Ground (more)... posted by JLR2000 on 12, 2001 at 5:50 PM:
Just to add to waht JLR2000 Stated, I thought I would test my ascii Skills, here is the two you need to connect. So According to the great pick, the left two are the ones you use. Geez, I hope this makes sense when I hit POST.
______
| |
_| |
| | |
| | |
|______|
|
|
: : Hey guys,
: : I'm still kind of stumped on wiring up my control panel to the encoder (hagstrom ke72)...
: : There are 3 connectors that come off of each microswitch... which ones do I wire up? Where do I wire them up to? What about the grounds?
: : I'm looking to wire them up with ide ribbon and 25pin cable (so i can unhook a control panel easily and swap it w/ a different one) sort of like MrSalty's (link at bottom) setup.
: : Would someonoe here help me out?
: : dunno how to properly wire up the buttons and joystick to the encoder.. there are 3 connectors from the switch and i'm stumped :/