Posted by Druin on 25, 2001 at 12:33 AM:
In Reply to: Re: I need a delay circuit for my coin door switches - anyone with ideas? posted by ChrisW on 24, 2001 at 9:01 PM:
: You could wire one side of the momentary switch to ground (as normal), and both the P4 Start and P1 Btn2 inputs to the other side of the switch. That way, when you hit the switch the I-PAC will register both inputs at the same time.
It should work but it would also force the p4 start and p1 btn2 to always be both activated at the same time even if just one or the other is pressed somewhere else on the controls because they'd be hard-wired together at this switch. I don't know if those buttons are used elsewhere in that layout - if not, then it's fine but if they also need to be activated individually as well as together, more isolation will be needed.