Re: Pushbutton Spacing

[ Follow Ups ] [ Post Followup ] [ Build Your Own Arcade Controls message board ] [ FAQ ]

Posted by SirPoonga on January 30, 2002 at 00:05:09:

In Reply to: Pushbutton Spacing posted by simpleman46 on January 28, 2002 at 00:16:59:

: Anybody know how close you can mount HAPP pushbuttons without the undersides interfering with eachother?

My panel I am putting them so there is an 1/8" between them. On the top the buttons are 1 1/4" (the hole being 1 1/8").

:And also, if you mount them this close on a wooden control panel, will the spaces between the holes be weakened too much?

Depends on the wood. MDf and good plywood are strong

: Also... what's the maximum control panel thickness that the buttons can mount on?

I have a 3/4" MDF. The buttons Just fit. Putting a 1/8" plastice on top, will need to counter sink buttons on bottom a little.

Follow Ups:

Post a Followup

Name:
E-Mail:

Subject:

Comments:
: : Anybody know how close you can mount HAPP pushbuttons without the undersides interfering with eachother? : My panel I am putting them so there is an 1/8" between them. On the top the buttons are 1 1/4" (the hole being 1 1/8"). : :And also, if you mount them this close on a wooden control panel, will the spaces between the holes be weakened too much? : Depends on the wood. MDf and good plywood are strong : : Also... what's the maximum control panel thickness that the buttons can mount on? : I have a 3/4" MDF. The buttons Just fit. Putting a 1/8" plastice on top, will need to counter sink buttons on bottom a little.

Optional Link address (start with http://):
Link Title:
Optional Image address (start with http://):

[ Follow Ups ] [ Post Followup ] [ Build Your Own Arcade Controls message board ] [ FAQ ]