Re: How to implement discrete logic circuit??

[ Follow Ups ] [ Post Followup ] [ Build Your Own Arcade Controls message board ] [ FAQ ]

Posted by Aaron on 6, 2001 at 3:16 PM:

In Reply to: How to implement discrete logic circuit?? posted by Munich on 6, 2001 at 11:06 AM:

: I have come up with a simple circuit that I hope can be used to make 8-way joysticks act more like 4-way joysticks. It consists of just a handful of logic gates -- nothing really complicated. I've run the circuit though a number of simulators and the results thus far look promising.

: So my question is how to realize this thing. I could do like I did in college and get a breadboard a few ICs and wire them all together, but I was hoping for something a little more elegant than that.

: Unfortunately, I have no experience with doing this any other way and I can't seem to find any good ideas on the internet. So, I ask you, is there a way to get a discrete logic circuit into a single chip, and if so, what would I need to do it?

: Regards,

: Munich

Check out the "Wire Joysticks" section on this page. This guy did exactly what you are talking about.

Scott's Unicade

Follow Ups:

Re: How to implement discrete logic circuit?? Derrick Renaud 3/07/2001 (2)
- That sounds great! (more...) Munich 3/08/2001 (1)
  - Re: That sounds great! (more...) Derrick Renaud 3/08/2001 (0)
...not exactly.... Munich 3/06/2001 (2)
- Re: ...not exactly.... Aaron 3/06/2001 (1)
  - Duh. *smacks forehead* (nt) Munich 3/06/2001 (0)

Post a Followup

Name:
E-Mail:

Subject:

Comments:
: : I have come up with a simple circuit that I hope can be used to make 8-way joysticks act more like 4-way joysticks. It consists of just a handful of logic gates -- nothing really complicated. I've run the circuit though a number of simulators and the results thus far look promising. : : So my question is how to realize this thing. I could do like I did in college and get a breadboard a few ICs and wire them all together, but I was hoping for something a little more elegant than that. : : Unfortunately, I have no experience with doing this any other way and I can't seem to find any good ideas on the internet. So, I ask you, is there a way to get a discrete logic circuit into a single chip, and if so, what would I need to do it? : : Regards, : : Munich : Check out the "Wire Joysticks" section on this page. This guy did exactly what you are talking about.

Optional Link URL:
Link Title:
Optional Image URL:

[ Follow Ups ] [ Post Followup ] [ Build Your Own Arcade Controls message board ] [ FAQ ]