Posted by dhansen on 28, 2000 at 3:39 AM:
In Reply to: Re: Arcade Monitor posted by dhansen on 28, 2000 at 2:39 AM:
Now I'm getting a weird error when I try to launch a game from arcadeos..the error reads
EXITING DUE TO SIGNAL SIGILL
then it says
INVALID OP CODE AT EP002C4054
Helllllppp!!
Doug
: Thanks, I'll give it a whirl.. I have both the vsync and hsync wires twisted together..is that what you mean by the hack? Please advise...
: Thanks again!!
: : Sounds like a 19". You probably won't go wrong w/ a hclock of 15.75 and a vclock of 60. If that works, try expanding your vclock to 50-60 and see if you can get anything in the PAL ranges (~50Hz). If not it's probably a standard NTSC arcade monitor. Also, make sure you have your vga hack cable connected to the Negative sync and not positive on the back of the monitor.
: : : Help!! I have an arcade monitor and I'm wondering what the hclock and vclock is for it so I can configure Advance Mame. The only markings I can find on the back are 19VMJP22, 19VMNP22, AND 510VJB22. I'm getting bad vertical roll with vertical games so I started using Advance Mame to correct the problem. If it's any help the cabinet was a Moon Patrol that was converted to Altered Beast but the monitor has Dig Dug burned into it.
: : : Thanks in advance for any help you can provide!!
: : : Dhansen