Posted by Joe on September 14, 1999 at 11:23:48:
In Reply to: Wiring LP24 Encoder posted by Nate Thompson on September 13, 1999 at 19:47:31:
Here is a link to that thread. As always, thanks Mr. Salty!
: I know this question has been asking a thousand times, but I want to make sure I've got this right. I have the LP24 and plan on using it in matrix mode with the layout described on the interface page of this site. What I am wondering is do I run the wire from column A, row 1 to the NO pin on the microswitch and run another wire from the COM to the ground pins on the LP24? Also, can I daisychain the ground wire between all buttons (i.e. run 1 wire to each ground and then back to the encoder)? Am I making any sense??? I hope so, the cabinet's done and now I'm into wiring.
: Also, if anyone has their LP24 config disc handy, could you please zip up the contents and email it to me at rocket@emu2k? I left mine down at my parent's house and its almost a 2 hour drive to get it.
: Thanks!
: Nate