Posted by Nate Thompson on September 13, 1999 at 19:47:31:
I know this question has been asking a thousand times, but I want to make sure I've got this right. I have the LP24 and plan on using it in matrix mode with the layout described on the interface page of this site. What I am wondering is do I run the wire from column A, row 1 to the NO pin on the microswitch and run another wire from the COM to the ground pins on the LP24? Also, can I daisychain the ground wire between all buttons (i.e. run 1 wire to each ground and then back to the encoder)? Am I making any sense??? I hope so, the cabinet's done and now I'm into wiring.
Also, if anyone has their LP24 config disc handy, could you please zip up the contents and email it to me at rocket@emu2k? I left mine down at my parent's house and its almost a 2 hour drive to get it.
Thanks!
Nate