I'm using a drill press--it doesn't have a reverse that I know of... NT

[ Follow Ups ] [ Post Followup ] [ Build Your Own Arcade Controls message board ] [ FAQ ]

Posted by rmfx on February 12, 2002 at 14:01:32:

In Reply to: ...I found a hole saw to be a pain.... posted by Munich on February 12, 2002 at 11:55:44:

: ...which is why I went out and got the 1 1/8" spade bit.

:
: : I'm sure you've probably already done this, but some people don't; make sure your drill is not set on reverse. If it is, a forstner bit will drill very slowly, and generate a LOT of heat.

: : Btw as to your original question, mdf is IMO the most easily worked of the bunch.




Follow Ups:


Post a Followup

Name:
E-Mail:

Subject:

Comments:

Optional Link address (start with http://):
Link Title:
Optional Image address (start with http://):

[ Follow Ups ] [ Post Followup ] [ Build Your Own Arcade Controls message board ] [ FAQ ]