A hole saw works very well, more...


[ Follow Ups ] [ Post Followup ] [ Build Your Own Arcade Controls message board ] [ FAQ ]

Posted by Garv on February 12, 2002 at 10:57:17:

In Reply to: BTW, what should I use to drill my button holes? The Forstner bit I'm using is too slow. NT posted by rmfx on February 12, 2002 at 01:14:07:

I'm sure you've probably already done this, but some people don't; make sure your drill is not set on reverse. If it is, a forstner bit will drill very slowly, and generate a LOT of heat.

Btw as to your original question, mdf is IMO the most easily worked of the bunch.



Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Optional Link address (start with http://):
Link Title:
Optional Image address (start with http://):


[ Follow Ups ] [ Post Followup ] [ Build Your Own Arcade Controls message board ] [ FAQ ]