Re: Cutting holes in a metal control panel


[ Follow Ups ] [ Post Followup ] [ Build Your Own Arcade Controls message board ] [ FAQ ]

Posted by wrybread on February 08, 2002 at 00:05:08:

In Reply to: Re: Cutting holes in a metal control panel posted by mhoward211 on February 05, 2002 at 16:19:58:

: You could also take the metal to a machine shop and have them "punch" the hole out. Shouldn't cost much and it would be a pretty nice cut.

Now that's a damn good idea, thanks. I've been putting off cutting into my Centipede metal control panel because it's so incredibly hard. I tried using a hole citter and got as far as completely snarling up a section of the control panel (yikes) before saying I need to find another way.

Yours is perfect, thanks.

: Michael





Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Optional Link address (start with http://):
Link Title:
Optional Image address (start with http://):


[ Follow Ups ] [ Post Followup ] [ Build Your Own Arcade Controls message board ] [ FAQ ]