Posted by Slater on 22, 2000 at 10:35 PM:
In Reply to: One for the electronics wizards... posted by Slater on 22, 2000 at 10:27 AM:
OK, I backed up and disconnected the 2nd controller and low and behold the original setup works again. So it is possible that the voltage amounts are dropping too much with the extra length and circuitry. I will shorten the extra cable for both controls and see how I go.
I must admit there is probably a good 4 - 6 feet of cable I can remove.
I'll let you guys know how I go. Thanks for your suggestions.