Re: NEWBIE QUES: How big to drill holes for joystick?


[ Follow Ups ] [ Post Followup ] [ Build Your Own Arcade Controls message board ] [ FAQ ]

Posted by Andy Desak on 15, 2000 at 5:04 PM:

In Reply to: Re: NEWBIE QUES: How big to drill holes for joystick? posted by c0nsumer on 15, 2000 at 1:28 PM:

: I used the exact same 1 1/8" bit that I used for the buttons for the joystick. Worked perfectly... There is a nice small gap between the joystick shaft and the wood of the control panel when the stick is pressed in any direction...

The 1 1/8 is fine.....I just reccommended the 1 1/4 for someone new to this in case they dont get the joystick centered perfectly it wont hit against the sides of the hole.


Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Optional Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Build Your Own Arcade Controls message board ] [ FAQ ]