Posted by Andy Desak on August 26, 1999 at 18:23:39:
In Reply to: Re: Suggestions for installing T Molding anyone? posted by Ryan Osborn on August 26, 1999 at 15:20:56:
: : I am building my cabinet and have ordered T molding. Could someone share their tips for cutting the groove the T Molding goes into. Also do you use glue or other tips tricks?
: : Thanks,
: : Bill
: I haven't put T-molding on my control panel yet, but I am planning on using a router with a 1/16" slot-cutting bit to make the groove. I've been assuming that the molding will fit tight enough that no glue will be required.
: I'll add a question of my own here. Should I cut a section of the molding insert off for sharp bends? It seems that the insert would bunch up otherwise.
The 1/16" slotting cutter is exactly the way to go. I would suggest trying a couple short practice pieces on some scrap wood to make sure you have the depth exactly right.
You do not need any glue...it is a nice tight fit.
As far as the corners are concerned you are once again correct....pound it in all the way to the bend and then cut about 1/2" of the tee part off and then just rap it around....use a rubber hammer and pound it in nice and tight.
I dont know your level of routing exp....but if you have never used one before be careful and take it slow. Even just a little carelessness can make a mess of your project....or even you!!
-Andy Desak
Arcade Solutions