Posted by Bill Connolly on August 26, 1999 at 14:38:08:
In Reply to: How do I drill and cut holes in plexiglass without breaking it? posted by Kevin747 on August 14, 1999 at 15:15:46:
I made a sandwich, scrap piece of wood, plexiglass, control panel particle board, scrap piece of wood. I clamped the sandwich together with 6 c clamps and drilled in forward with a 1 1/8 drill bit slowly. I used a brand new bit to make sure it was sharp. This prevented my plexiglass and control panel board from getting rough entry and exit cuts from the drilling, the top and bottom scrap took the hits.