Posted by JadeKnight on 25, 2000 at 12:47 PM:
In Reply to: Re: Another Question posted by Joel on 24, 2000 at 11:46 PM:
: Ok, X that last question, it has been answered. I am wondering how I am going to solder just one side though. Each side of the little circles has little bars going towards the other side (it is kind of hard to explain in words ^_^). Now how do I tell which side is grounded.
If you follow one side of the "bar" you are reffering to, you'll notice that it goes either to a chip or to another button. If it goes to another button, it's ground. The ground goes around the hole controller, button to button. (Read Common)
When I solder the one grounded side how do I "make it common".
The ground is allready common at the board. Sorry if I confused you here. It means that you only need to soldier one ground from your board, and use the same wire as ground to all your buttons. NB! You need one ground on each controller.
: Joel Garner
: Joel82@aol.com