Posted by Nightowl007 on 9, 2000 at 3:39 PM:
In Reply to: Re: Which material is thin, strong and easy to drill? posted by Andy Desak on 9, 2000 at 10:41 AM:
: : I was wondering if there is a material that is almost as strong as standard metal (used for actual control panels), that will resist warping and bending, and is just as thin and easy-to-drill holes in.
: : I'd appreciate help!
: : Thanks in advance
: You can use 1/16" aluminum. But I would suggest putting it over plywood.
: If you dont want to use wood underneath then I would only use steel.
Andy, where would one look for 1/16" aluminum?