Re: Difficult to remove TV case and make custom mount and bezel?


[ Follow Ups ] [ Post Followup ] [ Build Your Own Arcade Controls message board ] [ FAQ ]

Posted by Brian on 11, 2001 at 9:28 AM:

In Reply to: Difficult to remove TV case and make custom mount and bezel? posted by TDD on 11, 2001 at 1:05 AM:

I did this on my cabinet. Check out the monitor section on my web page below. It wasn't really too hard, but you have to be VERY!! careful. If the t.v. has been on at all, you could get shocked bad, and if you aren't careful while moving the tube around you could damage the yoke and crack it and once that's done, it's all over...time to buy another t.v. I think it's worth the effort since you have a t.v. that looks like a real arcade monitor when done by using the arcade bezel. Anyway, check it out..

Game on!! Brian


: I like the modularity of a TV as a display device, but I hate how it looks when mounted. I prefer the arcade monitor and a real, proper bezel that is moulded to the tube (like the ones HAPP sells)

: How tough is it to strip the case off a TV, build a frame for the whole mess, mount it, and especially, use a real bezel against the tube, and mimic the whole arcade look?

: Surely this must have been done by someone!




Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Optional Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Build Your Own Arcade Controls message board ] [ FAQ ]