Posted by Ohso on 18, 2001 at 4:27 PM:
In Reply to: Re: Happ trackball question posted by Dustin on 18, 2001 at 10:04 AM:
That's great news. I used a simple pocket knife to scrape away the paint and it's easy to avoid scraping the outside surface. Good luck.
: : I have a 3" happ trackball that spins perfectly, but when I put the bezel panel over it the fit is so tight that it restricts the spinning of the trackball. Anyone else have this problem. I'd file down the bezel but I don't want to risk scratching the finish.
: I contacted Happ about it and they are sending me a new one free of charge. I must say that I'm very impressed by their service. Hopefully this one will fit better, if not at least I'll have 2 chances to sand/file down the inside of the hole without mucking up the finish.