Posted by Dustin on 18, 2001 at 10:04 AM:
In Reply to: Happ trackball question posted by Dustin on 17, 2001 at 1:47 PM:
: I have a 3" happ trackball that spins perfectly, but when I put the bezel panel over it the fit is so tight that it restricts the spinning of the trackball. Anyone else have this problem. I'd file down the bezel but I don't want to risk scratching the finish.
I contacted Happ about it and they are sending me a new one free of charge. I must say that I'm very impressed by their service. Hopefully this one will fit better, if not at least I'll have 2 chances to sand/file down the inside of the hole without mucking up the finish.