Posted by Steve on 11, 2001 at 12:46 PM:
In Reply to: If you wanted to be careful, you wouldn't USE a router....... (more) posted by Intensify on 11, 2001 at 9:07 AM:
: If I was going to sink the faceplate into a control panel that was already built, I'd use a chisel and a hammer, or a friggin swiss army knife... :-/
Most Routers have that guide edge, so if you were worried about slipping, you could clamp some 2X4 to use as straightline guides and then go slowly and carefully. I had to do that with a lot of the routing on my CP cause I suck at drawing straight lines. Obviously didn't do that for the joysticks though cause nobody will look at the underside ;-)
Steve
C2M
">AZ Emu Group