Slot for T-Moulding

[ Follow Ups ] [ Post Followup ] [ Build Your Own Arcade Controls message board ] [ FAQ ]

Posted by Steve. G. on 7, 2001 at 11:50 AM:

Is there anything you can by that will insert into an ordinary electric drill to cut the slot for T-Moulding in 5/8 particle board ?

Thanks....

I used on of these...more dhansen 5/07/2001 (0)
I use a friend's table saw...with a Plywood blade...it is just under 1/8" and it worked great ! (nt) Mr Arcade 5/07/2001 (0)
Re: Slot for T-Moulding Just Michael 5/07/2001 (0)
a drill isn't going to cut particle board (nt) bob 5/07/2001 (3)
- Yes - it can... Xiaou2 5/08/2001 (2)
  - Re: Yes - it can... probably not a good idea. bob 5/08/2001 (0)
  - Thanks Everyone for your suggestions (nt) Steve. G. 5/08/2001 (0)

Post a Followup