Posted by Jason on 19, 2001 at 2:40 PM:
In Reply to: Question for WG D9200 Users posted by Kokuri on 19, 2001 at 2:37 PM:
: Ok, i'm wondering about bezel size and how wide one of your finished cabinets is, just so I know how long of a control panel I'll be able to have. Thanks for your assistance.
SPECIFICATION
CRT size (diagonal measure): 27”
Phosphor type: P22
Color Temperature: 8500K +/- 500K
Dot trio spacing: 0.71 mm (27”), invar mask
INPUT SIGNALS
CGA/EGA VGA
Input connector: 0.156 center header 15 pin D-sub high density male
Video input impedance: 4.7K Ohm 75 Ohm
Video level: 2.2 Vp-p 0.7 Vp-p
Video type: RGB analog
Sync type: TTL sync; separate or composite, negative or positive
Sync input impedance: 2.2K Ohm (H sync and V sync)
Horizontal sync frequency: 15.75 to 31.5 KHz
Vertical sync frequency: 45 to 90 Hz
LIGHT OUTPUT
70 Ft-L min. (center block)
GEOMETRY
Horizontal linearity: +/- 7%
Vertical linearity: +/- 5%
Picture size regulation: +/- 2%
Geometric distortion: +/- 2% max.
POWER INPUT
Input voltage: 90-264 VAC, 50-60 Hz; no isolation transformer required.
Maximum power: 150 watts typ. (27”),
USER CONTROLS
I2C bus remote controls: Brightness, contrast, horizontal size, horizontal position, vertical size, vertical position, pin cushion, trapezoid, color temperature, recall (factory reset).
Internal controls: Sub brightness, focus, G2 (screen), raster tilt, HV adjust.
MISCELLANEOUS
Operating temperature: 0 to 55 degree C.
Agency compliance: UL, CSA, DHHS, TUV, CE.
RESOLUTION
Graphics modes: Standard Res.:640 X 200
Mid Res.: 640 X 400
VGA: 640 X 480
Video bandwidth: 25 MHz typical.
DIMENSIONS
Height: 21.893" 556.08mm
Width: 24.390" 619.51mm
Depth: 19.479" 494.77mm