Posted by Fultra on 12, 2001 at 3:27 PM:
In Reply to: Re: Spinners....where? posted by Jackson on 12, 2001 at 2:06 PM:
I'm not sure if one of my spinner shafts would work or not. They are 4" long, .25" in diameter. You might be able to use it and cut it too length?
email me if you want one.
buckey29@yahoo.com
: I need the knob, but not necessarily the shaft. I wanted the shaft because the one I have is short since the spinner was designd for use with a metal control panel. I could work around this but would rather just buy a new shaft.