Todd did you get my email?


[ Follow Ups ] [ Post Followup ] [ Build Your Own Arcade Controls message board ] [ FAQ ]

Posted by Andy Warne on 31, 2001 at 3:16 AM:

In Reply to: ipac problems posted by Todd Munro on 30, 2001 at 2:30 AM:

Todd,

I replied but no answer yet. Let me know if you did'nt receive. Thanks Andy.

: I have finally finshed my panel, and I have a big problem. I hooked up my IPAC to one joystick and a couple of buttons and had unusal results. First I will explain the setup. I have 2 IPACs hooked up via PS/2, and the switchs I connected are on the 2nd IPAC. They are wired to P1 up, down, left, right, B1, B2. They have been daisy chained and grounded to the IPAC. Now, the irregular part is the IPAC is not putting out a consistent signal. It takes atleast 2 presses of any switch for it to register, and it misses press all over the place after that. What could be causing this? Keep in mind there is nothing hooked up to the 1st IPAC (besides the output and pass-thru from the 2nd IPAC). This occurs in both DOS(MAME & prompt) and Windows(Notepad). Any advice is greatly appreciated, especially if Andy himself could answer. Thanks in advance.




Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Optional Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Build Your Own Arcade Controls message board ] [ FAQ ]