Posted by Retrocactus on 4, 2001 at 12:09 PM:
In Reply to: Anyone here mounted a 360 wheel to a flat (horizontal, removable) control panel? I'm looking for ideas? (more) posted by robert mcelwee on 4, 2001 at 9:37 AM:
Assuming my photo works, I have a steering wheel mounted on my cabinet in the way you describe although it is a PC steering wheel and it's not 360 degrees.
The base has a giant suction cup and a screw mount clamp to hold it down. I was able to take it apart and reverse it so that it would face up instead of down...hopefully you can see this in the picture - I can take a few more if you need them.
My door comes off and all I have to do to mount it is slide the door out a little, attach the wheel and tighten the big screw mount (which is just under the middle of the control panel).
It takes about 15 seconds to install.
Hopefully this helps you.
John
aka Retrocactus