Posted by Fultra on 26, 2001 at 9:41 AM:
In Reply to: Re: Maybe..read on. posted by ZigRiz on 25, 2001 at 8:04 PM:
Read Tom A.'s post. You can also use the Optipac+
: Fultra,
: Thanks for taking the time to comment. Yes, I had seen your spinner. I said in my reply to jmarks comments my ideal controller that I build would be made up of "One Trackball, One spinner and three buttons". Can you recomend a controller that would support both your spinner, a track ball and three buttons?
: I need to do some more reading on the sunject tonight.
: Thanks again for your help.
: Zz
: : If you use part #:56-1100-00 then that is the right one...
: : Sinc my spinners are Happ compatible, I get a lot of questions about interfacing. The above part # is correct - just make sure you don't confuse it with their USB game developer kit which looks a lot like that.
: : : As a beginner in this area I'm looking for any help
: : : or advice you may be able to give me.
: : : I've wanted to start an Arcade project for some time now. Unfortunately I live in Bermuda and the market
: : : for old Arcade Cabs to modify is nill. Building
: : : from scratch is my only alternative. Before I embark
: : : on this project, I thought about getting my feet wet
: : : on a smaller controller project. I already own a HotRod so I was thinking of a Trackball or Spinner project.
: : : I was thinking of one trackball and three buttons in the design. Over at Happ, I was looking at the following:
: : : For the Interface, Happ offer this nice USB jobby. It
: : : looks like it will meet my needs.
: : : http://www.happcontrols.com/amusement/trackballs/55022600.htm
: : : My question is - Will I be able to use the 4 1/2" ball
: : : (part no. 55-0300-00) or does it only support the
: : : 2 1/4" trackball (part no. 56-5500-10)
: : : Another question is on the buttons. I'd like buttons
: : : like those in the HotRod. These look to be same same.
: : : http://www.happcontrols.com/amusement/pushbutts/5891xxl.htm
: : : I know these are questions I should be asking Happ.
: : : But I am hoping someone else has looked at these before
: : : and can save me from making an expensive mistake!
: : : I would appreciate any advice you can give.
: : : Thanks in advance.
: : : Z