Posted by Mike on September 25, 1999 at 05:18:55:
I have just brought a Jamma Cab with a 20" Monitor. I have connected the monitor to a PC-TV converter using the following wires from the scart lead 7 - Blue, 11 - Green, 15 - Red, 17 - Ground, 20 - Composite sync. (I got this info from Powerjaw posted on this message board)
Using Mames -monitor arcade option I just get a small scrambled rolling picture in the top left corner, however I put this down to the converter as I get the same image when using Mames -monitor pal option on a pal TV.
Using the converter with the arcade monitor and using mames default -monitor settings, (PC monitor) the picture looks great, but I can't stop the screen from rolling. (horizontally vertically and diagonally) After fiddling with various buttons for well over 3hours I have had the screen quite close, but I just can't seem to get it that last bit. The buttons I have been fiddling with are H Phase, V Shift, H Freq, V amp H Amp and V Freq.
Is this correct? Is their anything else I can try.
any information would be appreciated
Thanks Mike