Posted by Fultra on 6, 2001 at 11:40 AM:
In Reply to: Fultra spinner and Happs USB Interface posted by Ron Critchfield on 5, 2001 at 8:59 PM:
Ron,
The interface board I use is the same as Happs uses on their spinner and trackball. Therefore, if Happs says it works with their spinner, it will work with mine.
For the best answer to your question I would call HAPPS and ask for tech support. Lester has been a big help in the past!
Chris
: Has anyone got these two to work together? Apparently the Fultra Spinner is pin compatiable with the Serial version but it's not with the USB version. I'm trying to figure out which wires go where.
: Thanks,
: -Ron