Posted by Tom A. on 9, 2000 at 1:11 AM:
In Reply to: Re: Okay, what did I do wrong? posted by dhansen on 8, 2000 at 3:49 PM:
If you do decide to use separate H and V sync, you will notice there isn't separate syncs on the JAMMA connector. However, the monitor in the Impress does have the missing sync on the 6-pin connector on the monitor pcb. I ran a wire from this connector directly to the hacked vga cable and it worked just fine.
-Tom A.
: What kind of monitor do you have? I have a G07 CBO 19" and I had to split out my neg H-sync and neg v-sync connections to get it to work with my Trident Blade 3d card. With my the cirrus card I had before, twisting the two syncs together worked fine but this was not the case with the trident. Mr. Salty has a great monitor section you can use as a reference.
: http://www.mrsalty.net/arcade/monitor/signalconnect.jpg
: Good luck!