Posted by The Man on 27, 2000 at 3:36 PM:
Has anyone use the blue prints of the yoke you could get from TwistyGrip(YokeCraft)? For the materials they have you buy a 7/8 dowel and a 1/2 dowel but never tell you what to do with the 1/2 dowel. I'm to the point of putting in the 7/8 dowels and have no room to run the wires from the trigger buttons. Is this where I should be using the 1/2 dowel and I'm not to the point of putting in the dowel that runs through the shaft but I'm thinking I will have the same problem there?
Any help on this would be appreciated.
Thank you,
Kelly