I have a 20" Intergraph InterVue....


[ Follow Ups ] [ Post Followup ] [ Build Your Own Arcade Controls message board ] [ FAQ ]

Posted by Munchey on 31, 2000 at 12:01 PM:

In Reply to: I recently have gotten a 27" monitor. posted by Ron on 31, 2000 at 8:54 AM:

I believe my monitor is similar to yours. It is also a fixed frequency monitor. I picked it up for cheap to go into my to-be-created cocktail cabinet. In understand that if I were to have a Matrox graphics card, I could get a higher resolution out of it.

A couple of comments:

I will be using this monitor for vertical games only. Most work ok, but a couple do not. 1941 comes to mind. This is probably the monitor's fault, although it could be my PC. Currently it is being powered by a Dell Latitude LM100 laptop.

I am running DOS MAME and ArcadeOS. I did not have to do anything fancy to either of them to make them work.

The port on the back of the monitor is a 13w3 port. NOT the 5 connecter RCA (I really think ne means BNC) ports described below.

These monitors are great because they are big and extremely cheap. I bought my 20" for $87.

: I have gotten an old 27 in monitor the only does 640x480 at 60 htz. I was wondering if anyone has MAME working with a monitor like this. I think it came from an old CAD station. Also what games run at 640x480 or below.

: Thanks




Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Optional Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Build Your Own Arcade Controls message board ] [ FAQ ]