Barrier strip...


[ Follow Ups ] [ Post Followup ] [ Build Your Own Arcade Controls faq NEW message board ] [ FAQ ]

Posted by Cameron on July 14, 1999 at 10:05:34:

In Reply to: Re: Encoder Question... posted by Ray Iddings on July 14, 1999 at 08:53:36:

What is a barrier strip? Where do you get them. I am not finished with my wiring, but it is turning into a mess and I wouldn't mind a better way!
: Its really easy to do..First I would connect your buttons and stuff to a barrier strip then you can just screw the wires from your I/O header into the barrier strip. After that then you just need to run the set up program that comes with the encoder( it is very simple to use.) then your done and ready to rock. Just watch your common ground I had one of my solders come loose and only half of my panel worked at first (what a head scratch). Good Luck




Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Optional Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Build Your Own Arcade Controls faq NEW message board ] [ FAQ ]